[Previous][Next]
Diagnosis Procedure
1.CALIBRATION OF DECEL G SENSOR
Perform calibration of decel G sensor. Refer to Work Procedure.
: .
 
2.CALIBRATION OF SIDE G SENSOR
Perform calibration of side G sensor. Refer to Work Procedure.
: .
 
3.PERFORM DIAGNOSTIC TROUBLE CODE
With M.U.T.-III SE
  1. Electric motor switch OFF (Auto ACC function OFF) → ON → OFF (Auto ACC function OFF).
  2. Electric motor switch ON.
    noteWait at least 10 seconds after starting the engine.
  3. Perform Diagnostic Trouble Code for “ABS".
Is DTC “C10AC-54" detected?
Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.
INSPECTION END