Diagnosis Procedure
1.
PROGRAMMING OF ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
Perform programming of ABS actuator and electric unit (control unit). Refer to
Work Procedure
.
caution
Do not replace the ABS actuator and electric unit (control unit) until Diagnostic Trouble Code has been completed.
:
.
2.
CHECK DIAGNOSTIC TROUBLE CODE
With M.U.T.-III SE
Replace the ABS actuator and electric unit (control unit) even if other DTCs are displayed along with “C107C-53" in Diagnostic Trouble Code for “ABS".
:
Replace the ABS actuator and electric unit (control unit). Refer to
Removal and Installation
.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
..
With M.U.T.-III SE.