[Previous][Next]
Diagnosis Procedure
cautionDo not check between the harness connector terminals of the wheel sensor.
1.CHECK DTC DETECTION
Perform Diagnostic Trouble Code for "ABS".
Is the display result "C1065-4A" ?
Erase the DTC set in "ABS".
 
2.REPLACE WHEEL SENSOR
  1. Replace the RR LH wheel sensor. Refer to Removal and Installation.
    noteWhen the RR LH wheel sensor, which is removed before the recent electric motor switch ON operation, is not installed to the original position, replace the RR LH wheel sensor.
  2. Connect the battery negative terminal.
  3. Perform Diagnostic Trouble Code for “ABS".
Is the display result "C1065-4A" of “Active DTC"?
Replace the ABS actuator and electric unit (control unit). Refer to Removal and Installation.
Erase the DTC set in "ABS".