[Previous][Next]
Inspection and Adjustment
 
 
INSPECTION AFTER REMOVAL
  • Replace the shims and shim covers if rust is excessively attached.
  • Eliminate rust on the pad and the torque member. Replace them if rust is excessively attached.
 
 
INSPECTION AFTER INSTALLATION
  • Check a drag of rear disc brake. If any drag is found, follow the procedure described below.
 
 
1. Remove brake pads. Refer to Removal and Installation.
2. Press the pistons. Refer to Removal and Installation.
3. Install brake pads. Refer to Removal and Installation.
4. Depress the brake pedal several times.
5. Check a drag of rear disc brake again. If any drag is found, disassemble the cylinder body and replace if necessary. Refer to Disassembly and AssemblyDisassembly and Assembly.
  • Burnish contact surfaces brake pads and disc rotor after refinishing or replacing brake pads, or if a soft pedal occurs at very low mileage. Refer to Inspection and AdjustmentInspection and Adjustment.