1. Remove the sliding pin bolt, and remove the cylinder body from the torque member. Refer to Removal and Installation.caution | Fix the brake pad at suitable tape so that the brake pad will not drop. |
2. Remove sliding pins and sliding pin boots from torque member.
3. Remove bushing from sliding pin . 4. Place a wooden block as shown in the figure, and blow air from union bolt mounting hole to remove piston boot.caution | Never get fingers caught in the piston. |
5. Remove piston seal from cylinder body using seal pick tool.caution | Be careful not to damage a cylinder inner wall. |
6. Remove bleeder valve and cap.