[Previous][Next]
Inspection
 
 
COMPONENT PART
Make sure that the mounting conditions (looseness, backlash) of each component and component conditions (wear, damage) are normal. If any abnormalities are found, replace the parts.
 
 
WHEEL HUB ASSEMBLY (BEARING-INTEGRATED TYPE) END PLAY
1. Raise the vehicle.
2. Move the tires by hand and check to make sure there is no looseness. In particular, check the tires by tilting them to the left and right and shaking them by hand. If there is looseness, apply the brake and check again whether there is looseness. If the looseness goes away, then there is looseness in the wheel hub and bearing assembly and not the suspension.
Axial end play: Refer to Wheel Bearing.
3. Spin the tires forward and backward by hand, and check that there is no looseness or abnormal noise.
4. If any looseness or abnormal noise occur, replace the wheel hub and bearing assembly. Refer to Removal and Installation.