CHECK AND REPLACEMENT OF HIGH-VOLTAGE FUSE INSIDE THE JUNCTION BOX

CHECK AND REPLACEMENT OF HIGH VOTAGE FUSE INSIDE THE JUNCTION BOX

danger

When servicing the junction box, disconnect the rear interlock connector in addition to the service plug removal. (Refer to PRECAUTIONS ON HOW TO USE THE HIGH-VOLTAGE VEHICLE

1. Remove the junction box upper lid (Refer to JUNCTION BOX REMOVAL AND INSTALLATION

2. Remove the each mounting bolts, and remove the each high voltage fuses.

3. Check the resistance between the each high voltage fuses. If there is no continuity (open circuit), replace the high voltage fuses.

caution

When tightening the mounting bolts, secure the high-voltage fuse terminal portion, because there is a risk of damage to the high-voltage fuse when an excessive force applies to the high-voltage fuse main body.

Tighten each mounting bolt to the specified torque.

Tightening torque: 8.0 ± 1.0 N·m (71 ± 8 in-lb)

5. Install the junction box upper lid (Refer to JUNCTION BOX REMOVAL AND INSTALLATION