![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
| Item No. | Item | Content | Normal condition |
| 30 | Parallel run check mode | Activate the parallel run check mode. | Refer to data list item No. 1570 DATA LIST REFERENCE TABLE . |
| 210 | LOCK CHARGING CONNECTOR | Actuate the charge connector lock actuator for lock operation. | Charge connector lock actuator rod: Protruding |
| Item No. | Item | Content | Normal condition |
| 10 | EV Coolant refilling control | Actuate the electric water pump intermittently to refill the coolant. | The electric water pump is intermittently actuated. |
| Item No. | Item | Content | Normal condition |
| 40 | Engine compression measurement | Crank the engine. | Refer to Engine Mechanical - Compression Pressure Check COMPRESSION PRESSURE CHECK. |
| Item No. | Item | Content | Normal condition | |
| 50 | Maintenance mode | Emission test | Activate the continuous idling mode. | The continuous idling mode is activated. |
| 4WD C/D mode | (This item is displayed, but it is not used.) | – | ||
| 51 | Maintenance mode (stop) | Stop the maintenance mode. | The maintenance mode is stopped. | |
| Item No. | Item | Content | Normal condition |
| 90 | Control signal 1 for Charge port Lid Unlock Actuator | Select ON to actuate the EV charger lid lock release actuator for unlock operation. | The EV charger lid lock release actuator unlock operation |
| Item No. | Item | Content | Normal condition |
| 110 | Control signal 2 for Charge Connector Unlock Actuator | Select ON to actuate the charge connector lock actuator for unlock operation. | The charge connector lock actuator unlock operation |
| Item No. | Item | Content | Normal condition |
| 1 | Compulsion Boot Test Request | Forcibly activate the PHEV-ECU when the DTC No. U3D01-06 is set. | When DTC No. U3D01-06 is set due to low 12V battery voltage, the system will be recovered after performing this item. |