[Previous][Next]
DTC No. P0D59-00 Proximity Detection Circuit High
 
 
 
 
DTC SET CONDITION
Check Condition
  • The IGCT power supply is ON.
Judgment Criterion
  • The high input of the on board charger connection signal is detected.
 
 
TROUBLESHOOTING HINTS
  • Damaged wiring harness and connectors
  • Malfunction of the PHEV-ECU
 
 
DIAGNOSIS
Required Special Tools:
  • MB992744: Vehicle communication interface-Lite (V.C.I.-Lite)
  • MB992745: V.C.I.-Lite main harness A
  • MB992747: V.C.I.-Lite USB cable short
  • MB992748: V.C.I.-Lite USB cable long
1.Check wiring harness and connectors for damage.
Check the wiring harness and connectors in NCCP line between the PHEV-ECU connector and On Board Charger (OBC) connector for damage.
Is the check result normal?
Repair the connector(s) or wiring harness.
 
2.Check whether the DTC is set again.
Is the DTC set?
Replace the PHEV-ECU (Refer to PHEV-ECU REMOVAL AND INSTALLATION).
The trouble can be an intermittent malfunction (Refer to General Information - How to Use Troubleshooting/Inspection Service Points, How to Cope with Intermittent Malfunctions HOW TO COPE WITH INTERMITTENT MALFUNCTIONS).