[Previous][Next]
DTC No. P0D58-00 Proximity Detection Circuit Low
 
 
 
 
DTC SET CONDITION
Check Condition
  • The IGCT power supply is ON.
Judgment Criterion
  • The low input of the on board charger connection signal is detected.
 
 
TROUBLESHOOTING HINTS
  • Damaged wiring harness and connectors
  • Malfunction of the charging cable
  • Malfunction of the PHEV-ECU
noteThe DTC No. P0D58-00 may be set due to the following external factors.
  • Malfunction of the external power supply equipment
 
 
DIAGNOSIS
Required Special Tools:
  • MB992744: Vehicle communication interface-Lite (V.C.I.-Lite)
  • MB992745: V.C.I.-Lite main harness A
  • MB992747: V.C.I.-Lite USB cable short
  • MB992748: V.C.I.-Lite USB cable long
  • MB991223: Wiring harness set
  • MB992006: Extra fine probe
1.Check of continuity at PHEV-ECU connector (NCCP terminal)
(1) Disconnect the PHEV-ECU connector (B508), and measure at the wiring harness side.
(2) Check the continuity between the PHEV-ECU connector (NCCP terminal) and body ground.
OK: No continuity
Is the check result normal?
Repair the connector(s) or wiring harness in NCCP line between the PHEV-ECU connector and On Board Charger (OBC).
 
2.Charging cable check
Check the charging cable (Refer to EV HOME & QUICK CHARGER CABLE REMOVAL AND INSTALLATION).
Is the check result normal?
Replace the charging cable (Refer to EV HOME & QUICK CHARGER CABLE REMOVAL AND INSTALLATION).
 
3.Check whether the DTC is set again.
(1) Erase the set DTC.
(2) Perform the normal charging.
(3) Check whether the DTC is set again.
Is the DTC set?
Replace the PHEV-ECU (Refer to PHEV-ECU REMOVAL AND INSTALLATION).
The trouble can be an intermittent malfunction (Refer to General Information - How to Use Troubleshooting/Inspection Service Points, How to Cope with Intermittent Malfunctions HOW TO COPE WITH INTERMITTENT MALFUNCTIONS).