[Previous][Next]
REMOVAL AND INSTALLATION
 
 
caution•Handle the canister as follows.
  1. Do not allow grease or other oil to adhere to the O-ring when mounting the mating parts. When using an auxiliary insertion agent, use isopropyl alcohol.
  2. Do not directly touch the connector terminal of the evaporative leak check module (ELCM) section because there is a possibility that the IC chip may be damaged by static electricity.
  3. Do not use the canister when it has been dropped.
  4. Do not allow water, gasoline etc. to adhere to the connector section.
  5. Do not transport it by holding the ELCM section.
•Handle the fuel tank solenoid valve as follows.
  1. Do not use the fuel tank solenoid valve when it has been dropped.
  2. Do not transport it by holding the relief valve section and the hose section.
  3. Handle it so that the pipe seal section of each nipple will not be scratched.
  4. Because connecting the tube or harness connector may cause a grommet break, perform it after fixing the fuel tank solenoid valve body.
Fuel vapor canister removal steps
•Rear Suspension Member (Refer to Suspension - Rear Suspension, Rear Suspension Member Removal and InstallationRemoval and Installation)
1.Bypass valve connector connection
2.Fuel vapor hose
3.Fuel vapor tube
4.Fuel vapor canister
5.Fuel vapor canister bracket
Fuel vapor sub canister removal steps
6.Fuel vapor hose bracket
7.Fuel vapor control line tube
8.Fuel vapor sub canister
9.Fuel vapor sub canister bracket
Evaporative leak check module (ELCM) removal steps
10.ELCM connector
11.Fuel vapor control line hose A
12.Fuel vapor control line connector
13.Fuel vapor control line cap
14.Fuel vapor control line hose B
15.Evaporative leak check module (ELCM)
16.ELCM bracket
17.Fuel vapor canister air filter
Fuel tank solenoid valve removal steps
18.Fuel tank solenoid valve connector
19.Fuel vapor hose connector
20.Fuel tank solenoid valve