[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal Operation
  • Rear Wheel House Splash Shield Removal (Refer to Body Exterior, Doors, Roof & Vehicle Security - Exterior, Splash shield Removal and Installation REMOVAL AND INSTALLATION)
  • Rear Suspension Member Removal (Refer to Suspension - Rear Suspension Member Removal and Installation)
 
 
Post-installation Operation
  • Rear Suspension Member Installation (Refer to Suspension - Rear Suspension Member Removal and Installation)
  • Rear Wheel House Splash Shield Installation (Refer to Body Exterior, Doors, Roof & Vehicle Security - Exterior, Splash shield Removal and Installation REMOVAL AND INSTALLATION)
 
 
Removal steps
1.Fuel cap
2.Fuel filler tube
 
 
REMOVAL SERVICE POINT
 
 
<<A>> FUEL FILLER TUBE REMOVAL
As illustrated, while pressing the top of the retainer down, push the retainer as a whole into the center and cut its connection.
 
 
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< FUEL FILLER TUBE INSTALLATION
1. Prior to installation, upon spreading the retainer to the side of the mark indicated in the illustration and avoiding the claws, and raise it until a sound can be heard.
2. Securely attach the connector of the fuel tube, then push the retainer of the connector down, and lock it securely.
cautionAfter attaching it, gently tug on the fuel tube to confirm that it does not detach. At the same time, check that the tube has around 1 mm (0.03 inch) of play.