[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No.M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
B2E12-55Configuration
(Configuration)
Diagnosis conditionWhen ignition switch is ON
Signal (terminal)
ThresholdConfiguration not complete
Diagnosis delay time1 second or more
 
 
POSSIBLE CAUSE
  • System configuration has not been made or is in complete.
  • TCU
 
 
FAIL-SAFE
TCU has not been initialized
 
 
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With M.U.T.-III SE
  1. Turn ignition switch ON.
  2. Turn ignition switch OFF and wait at least 30 seconds.
  3. Turn ignition switch ON and wait at least 30 seconds or more.
  4. Select “Self Diagnostic Result” mode of “IVC” using M.U.T.-III SE.
  5. Check DTC.
Is DTC B2E12‐55 detected?
-1To check malfunction symptom before repair: Refer toIntermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END