[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No. M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
B2E08–01Microphone
(Microphone)
1Diagnosis conditionWhen ignition switch is ON.
Signal (terminal)Microphone signal
Threshold7.2 V or more
Diagnosis delay time1 second or more
2Diagnosis conditionWhen ignition switch is ON.
Signal (terminal)Microphone signal
Threshold0.2 V or less
Diagnosis delay time1 second or more
 
 
POSSIBLE CAUSE
  • Microphone signal circuit short to power supply
  • Microphone signal circuit short to ground
  • Microphone
 
 
FAIL-SAFE
Microphone does not operate
 
 
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With M.U.T.-III SE
  1. Turn ignition switch ON.
  2. Turn ignition switch OFF and wait at least 30 seconds.
  3. Turn ignition switch ON and wait at least 30 seconds or more.
  4. Select “Self Diagnostic Result” mode of “IVC” using M.U.T.-III SE.
  5. Check DTC.
Is DTC B2E08-01 detected?
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END