[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No. M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
B2756-94Rear sensor
(Rear sensor)
Diagnosis conditionWhen ignition switch is ON
Signal (terminal)Rear sensor signal
ThresholdPersistent noise
Diagnosis delay time1 seconds or more
 
 
POSSIBLE CAUSE
Persistent noise in the rear sensors ultrasonic range (exhaust sound, heavy rain, horn) not filtered out by signal processing.
 
 
FAIL-SAFE
Obstacle detection function is deactivated.
 
 
CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With M.U.T.-III SE
  1. Turn ignition switch ON.
  2. Turn ignition switch OFF and wait for 30 seconds.
  3. Turn ignition switch ON and wait at least 2 seconds or more.
  4. Select “Self Diagnostic Result” mode of “SONAR” using M.U.T.-III SE.
  5. Check DTC.
Is DTC B2756-94 detected?
Proceed to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END