Diagnosis Procedure
1.
CHECK REAR SONAR SENSOR SIGNAL RH SIDE CIRCUIT (1)
Turn ignition switch OFF.
Disconnect sonar control unit connector and rear sonar sensor RH side connector.
Turn ignition switch ON.
Check voltage between sonar control unit harness connector and ground.
Sonar control unit
(-)
Voltage (Approx. )
Connector
Terminal
B49
50
Ground
0 V
Is the inspection result normal?
Repair harness or connector.
2.
CHECK REAR SONAR SENSOR SIGNAL RH SIDE CIRCUIT (2)
Turn ignition switch OFF.
Check continuity between rear sonar sensor RH side harness connector and ground.
Rear sonar sensor RH side
Ground
Continuity
Connector
Terminal
B464
2
Not existed
Is the inspection result normal?
Replace the rear sonar sensor RH side. Refer to
Removal and Installation
.
Repair the harness or connector.