[Previous][Next]
Removal and Installation
 
 
REMOVAL
 
 
1. Remove 12V battery. Refer to Removal and Installation.
2. Remove air cleaner cover .
3. Press the pawl of engine room harness and pull up engine room harness in the direction of the arrow.
: Pawl
4. Remove battery mounting bracket mounting bolts , and then remove the battery mounting bracket from the battery tray 2.
5. Remove battery tray 2 mounting bolts from battery tray 2.
6. Disconnect ECM connector from ECM.
7. Remove battery tray 2 mounting bolt , and then remove the battery tray 2 from the battery tray 1.
8. Remove battery fix rod from battery tray 2 .
9. Remove battery tray 1 mounting bolts from battery tray 1.
10. Remove harness clip , and then remove the battery tray 1 from the vehicle.
 
 
INSTALLATION
Note the following, and install in the reverse order of the removal. Refer to Required Procedure After Battery Disconnection.