Diagnosis Procedure
1.
CHECK IGNITION RELAY-2 CONTROL SIGNAL CIRCUIT (SHORT TO BATTERY)
Ignition switch OFF.
Remove ignition relay-2.
Disconnect BCM connector.
Check voltage between BCM harness connector and ground.
+
-
Voltage
BCM
Connector
Terminal
M18
33
Ground
0 V
Is the inspection result normal?
Repair the harness or connector.
2.
CHECK IGNITION RELAY-2
Check ignition relay-2. Refer to
Component Inspection
.
Is the inspection result normal?
Replace BCM. Refer to
Removal and Installation
.
Replace ignition relay-2.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
Repair the harness or connector..Replace BCM. Refer to Removal and Installation.Replace ignition relay-2.