[Previous][Next]
Diagnosis Procedure
1.CHECK FUSE AND FUSIBLE LINK
  1. Ignition switch OFF.
  2. Check that the following IPDM E/R fuse and fusible link is not blown (open).
    Signal nameFuse and Fusible link No.
    Battery power supplyB (140A)
    X (30A)
Is the fuse and fusible link blown (open)?
Replace the blown (open) fuse or fusible link after repairing the affected circuit if a fuse or fusible link is blown (open).
.
 
2.CHECK BATTERY POWER SUPPLY VOLTAGE
  1. Disconnect IPDM E/R connector.
  2. Check voltage between IPDM E/R harness connector and ground.
    +-Voltage
    IPDM E/R
    ConnectorTerminal
    F4181Ground6 – 16 V
Is the inspection result normal?
Replace IPDM E/R. Refer to Removal and Installation.
Repair the battery power supply circuit.