[Previous][Next]
REMOVAL AND INSTALLATION
 
 
Pre-removal Operation
Post-installation Operation
Front door assembly removal steps
1.Wiring harness connector connection
2.Door check connecting bolt
3.Front door assembly
Front door hinge removal steps
3.Front door assembly
4Front door upper hinge
5.Front door lower hinge
Striker removal steps
6.Striker
7.Shim
Bumper removal
8.Bumper
Rear door assembly removal steps
1.Wiring harness connector connection
2.Door check connecting bolt
3.Rear door assembly
Rear door hinge removal steps
3.Rear door assembly
Center pillar lower garnish (Refer to Interior Trim REMOVAL AND INSTALLATION)
4.Rear door upper hinge
5.Rear door lower hinge
Striker removal steps
6.Striker
7.Shim
 
 
INSTALLATION SERVICE POINT
 
 
>>A<< STRIKER INSTALLATION
Align the center of the striker and lock within ± 1.5 mm (± 0.06 inch), and install.