[Previous][Next]
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
Dash Side Finisher Removal and Installation (Refer to REMOVAL AND INSTALLATION).
 
 
Removal steps
1.Instrument mask RH
2.Instrument panel pad RH
Cluster lid (Refer to Removal and Installation).
3.Instrument panel air outlet panel assembly
4.Instrument panel side air outlet
5.Instrument panel center air outlet
6.Push-button ignition switch
7.Hazard switch
8.Instrument panel air outlet panel
Required Special Tool:
  • MB990784: Ornament Remover
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> INSTRUMENT MASK RH REMOVAL
Remove the clips shown in the figure using ornament remover (Special tool: MB990784).
 
 
 
<<B>> INSTRUMENT PANEL PAD RH REMOVAL
Remove the clips shown in the figure using ornament remover (Special tool: MB990784).
 
 
 
<<C>> INSTRUMENT PANEL AIR OUTLET PANEL ASSEMBLY REMOVAL
1. Remove the installation screws.
2. Remove the clips shown in the figure using ornament remover (Special tool: MB990784).