[Previous][Next]
REMOVAL AND INSTALLATION
Pre-removal and Post-installation Operation
Dash Side Finisher Removal and Installation (Refer to REMOVAL AND INSTALLATION).
 
 
Removal steps
1.Instrument mask LH
2.Instrument panel pad LH
Cluster lid (Refer to Removal and Installation).
3.Instrument panel air outlet panel assembly
4.Instrument panel side air outlet
5.Instrument panel air outlet panel
6.Fuse block lid
7.Instrument lower panel LH assembly
8.Switch or switch plug
9.Instrument lower panel LH
Required Special Tool:
  • MB990784: Ornament Remover
 
 
REMOVAL SERVICE POINTS
 
 
<<A>> INSTRUMENT MASK LH REMOVAL
Remove the clips shown in the figure using ornament remover (Special tool: MB990784).
 
 
 
<<B>> INSTRUMENT PANEL PAD LH REMOVAL
Remove the clips shown in the figure using ornament remover (Special tool: MB990784).
 
 
 
<<C>> INSTRUMENT PANEL AIR OUTLET PANEL ASSEMBLY REMOVAL
1. Remove the installation screws.
2. Remove the clips shown in the figure using ornament remover (Special tool: MB990784).
 
 
 
<<D>> INSTRUMENT LOWER PANEL LH ASSEMBLY REMOVAL
1. Remove the installation screws.
2. Remove the clips shown in the figure using ornament remover (Special tool: MB990784).