[Previous][Next]
Diagnosis Procedure
note
  • Perform self-diagnoses with M.U.T.-III SE before performing symptom diagnosis. If any DTC is detected, perform the corresponding diagnosis.
  • Check that refrigerant is enclosed in cooler cycle normally. If refrigerant amount is shortage from proper amount, perform the inspection of refrigerant leakage.
1.CHECK MAGNETIC CLUTCH OPERATION
Check magnetic clutch. Refer to Component Function Check.
Does it operate normally?
.
Repair or replace malfunctioning parts.
 
2.CHECK REFRIGERANT PRESSURE SENSOR
Check refrigerant pressure sensor. Refer to Diagnosis ProcedureDTC Diagnosis Procedure.
Is the inspection result normal?
.
Repair or replace malfunctioning parts.
 
3.CHECK A/C AMP. OUTPUT SIGNAL
With M.U.T.-III SE
  1. Select “Data List” mode of “HVAC” using M.U.T.-III SE.
  2. Select “COMP REQ SIG” and “FAN REQ SIG”, and check status under the following conditions.
Monitor itemConditionStatus
COMP REQ SIGA/C switchOFF (A/C switch indicator: OFF)Off
ON (A/C switch indicator: ON)On
FAN REQ SIGFront blower motorOFFOff
ONOn
Is the inspection result normal?
Replace IPDM E/R. Refer to Removal and Installation.
Replace A/C amp. Refer to A/C AMP. REMOVAL AND INSTALLATION.