1.CHECK INTAKE DOOR MOTOR POWER SUPPLY
2.CHECK INTAKE DOOR MOTOR GROUND CIRCUIT FOR OPEN
3.CHECK INTAKE DOOR MOTOR LIN SIGNAL CIRCUIT
- Connect intake door motor connector and A/C amp. connector.
- Ignition switch ON.
- Confirm output waveform between intake door motor harness connector and A/C amp. harness connector with oscilloscope.
+ | − | Output waveform |
Intake door motor | A/C amp. |
Connector | Terminal | Connector | Terminal |
M147 | 3 | M55 | 58 | |
Is the inspection result normal?
.
4.CHECK INTAKE DOOR MOTOR POWER SUPPLY CIRCUIT FOR OPEN
5.CHECK INTAKE DOOR MOTOR POWER SUPPLY CIRCUIT FOR SHORT
- Disconnect following connectors.
- Air mix door motor LH
- Air mix door motor RH
- Air mix door motor (rear)
- Mode door motor
- Check continuity between intake door motor harness connector and ground.
Intake door motor | — | Continuity |
Connector | Terminal |
M147 | 1 | Ground | Not existed |
Is the inspection result normal?
Repair harness or connector.
6.CHECK INTAKE DOOR MOTOR LIN SIGNAL CIRCUIT FOR OPEN
7.CHECK INTAKE DOOR MOTOR LIN SIGNAL CIRCUIT FOR SHORT
- Disconnect following connectors.
- Air mix door motor LH
- Air mix door motor RH
- Air mix door motor (rear)
- Mode door motor
- Check continuity between intake door motor harness connector and ground.
Intake door motor | — | Continuity |
Connector | Terminal |
M147 | 3 | Ground | Not existed |
Is the inspection result normal?
Repair harness or connector.