[Previous][Next]
Removal and Installation
 
 
warning
  • Be sure to check precautions and notes by referring to PRECAUTIONS before work.Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"
  • Always observe the following items for preventing accidental activation.
    • Before servicing, ignition switch OFF, disconnect battery negative terminal and wait for 3 minutes or more (discharges electricity held in the additional power supply circuit of the air bag diagnosis sensor unit).
    • Before disconnecting the air bag sensor unit harness connector, be sure to disconnect each harness connector of the air bag modules, seat belt pre-tensioners and lap pre-tensioner to prevent air bag deployment by static electricity and seat belt pre-tensioner operation.
    • Never use air tools or electric tools for servicing (prevents the air bag diagnosis sensor unit from activating unexpectedly due to vibration).
  • When the air bag diagnosis sensor unit is replaced with a new one, write the vehicle identification number (VIN) into the air bag diagnosis sensor unit by using the M.U.T.-III SE.
Pre-removal Operation
Turn the ignition switch to the "LOCK" (OFF) position.
Removal steps
Disconnect the negative (-) battery terminal.
Center console assembly (Refer to Floor Console Assembly Removal and Installation)
1.Ground bolt
2.Air bag diagnosis sensor unit
Installation steps
2.Air bag diagnosis sensor unit
1.Ground bolt
Center console assembly (Refer to Floor Console Assembly Removal and Installation)
Connect the negative (-) battery terminal.
Post-installation inspection
 
 
REMOVAL SERVICE POINT
 
 
<<A>> AIR BAG DIAGNOSIS SENSOR UNIT REMOVAL
Turn the lock lever (A in the figure) of the air bag diagnosis sensor unit harness side connector toward the direction of the arrow to release the lock lever, and remove the connector.
 
caution
  • To prevent damage to the air bag diagnosis sensor unit, never impact it
  • Replace air bag diagnosis sensor unit if it is dropped or sustains an impact.
  • Replace air bag diagnosis sensor unit of deployed driver air bag module, deployed passenger air bag module, deployed driver knee air bag module, deployed passenger knee air bag module, deployed front side air bag module, deployed front center air bag module, deployed rear side air bag module, deployed curtain air bag module, deployed seat belt pre-tensioner or deployed lap pre-tensioner.
 
 
 
INSTALLATION SERVICE POINTS
 
 
>>A<< GROUND BOLT INSTALLATION
Check the head mark "E" and install the ground bolt.
 
 
 
>>B<< POST-INSTALLATION INSPECTION
caution
  • Never damage the harness while installing.
  • Be sure to perform ADDITIONAL SERVICE WHEN REPLACING AIR BAG DIAGNOSIS UNIT when replacing air bag diagnosis sensor unit. Or not doing so, air bag diagnosis sensor unit control function does not operate normally. Refer to Description.
  • After installation is completed, perform self-diagnosis using M.U.T.-III SE or air bag warning light, if the system is normal and "Stored DTC" of "Self-diagnosis" is indicated, always perform "Erase DTCs" of "Self-diagnosis" using M.U.T.-III SE. Refer to Work Flow Work Flow.
  • After the work is completed, check that no system malfunction is detected by air bag warning light.