[Previous][Next]
Removal and Installation
 
 
REMOVAL
 
 
1. Remove engine cover. Refer to Removal and Installation.
2. Remove 12V battery. Refer to Removal and Installation.
3. Remove the vacuum hose and vacuum piping.
4. Perform inspection after removal. Refer to Inspection.
 
 
INSTALLATION
Note the following, install the vacuum hose.
noteWhen the insertion of vacuum hose is difficult, applying volatile alcohol shall be acceptable. However the volatile alcohol shall be composed from ethanol, N-propyl alcohol and isopropyl alcohol.
  • When installing vacuum hose, insert it until its tip reaches the back-end of length (A) or further as shown in the figure.
    A: 24 mm (0.95 in) or more
  • Yellow marking should face vehicle from vacuum hose should be until spool.
  • Make sure the stamp indicating the direction of engine.
    : Vehicle front
  • Face the paint mark of vacuum hose (intake manifold side) to upward assemble.
  • Face the paint mark of vacuum hose (brake booster side) to upward assemble.
  • Face the paint mark of vacuum piping to upward to assemble.
  • Face the other paint marks to upward to assemble.
  • For clamp mounting direction (the orientation of pawl), refer to Exploded View.