[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTC No. M.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
C170086Control unit
(Control unit)
Diagnosis conditionDrive the vehicle at 40 km/h (25MPH) or more.
noteWhen DTC is memorized, DTC is displayed again at ignition switch ON.
Signal (terminal)Vehicle speed signal
ThresholdVehicle speed signal is not detected.
Diagnosis delay time2 seconds or more.
 
 
POSSIBLE CAUSES
  • CAN communication
  • ABS actuator and electric unit (control unit) malfunction
  • BCM
 
 
DTC CONFIRMATION PROCEDURE
1.CONFIRMATION PROCEDURE
With M.U.T.-III SE
  1. Drive the vehicle at 40 km/h (25MPH) or more.
  2. Stop the vehicle.
  3. Perform “Self-diagnosis” of “BCM”.
Is DTC “C1700-86” detected?
Refer to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END