[Previous][Next]
Adjustment
 
 
ADJUSTMENT BEFORE REMOVAL
 
 
AWD Control Unit Part Number Saving
When replacing AWD control unit (integrated with actuator assembly of electro-hydraulic coupling assembly) and electro-hydraulic coupling assembly, perform AWD control unit part number saving. Refer to Description.
 
 
ADJUSTMENT AFTER INSTALLATION
 
 
AWD Control Unit Programming
When replacing AWD control unit (integrated with actuator assembly of electro-hydraulic coupling assembly) and electro-hydraulic coupling assembly, perform programming to AWD control unit. Refer to Description.
 
 
Electro-Hydraulic Coupling Oil Filling, Air Bleeding and Initialize Oil Deterioration Level
When the electro-hydraulic coupling oil is drained, such as when replacing or removing/installing electro-hydraulic coupling component parts, the air bleeding and initialize oil deterioration level of electro-hydraulic coupling oil is required after fill with new electro-hydraulic coupling oil.
Refilling for electro-hydraulic coupling oil
Fill with electro-hydraulic coupling oil following the instructions below.
1. Remove filler plug and gasket from coupling oil tank cover .
2. Fill with new electro-hydraulic coupling oil to specified amount.
Specified amount : Approx. 0.6 (1-1/4 US pt, 1 lmp pt)
caution
  • Use only genuine Mitsubishi Motors parts for electro-hydraulic coupling oil.
  • When using oil, allow the additives to diffuse well before use.
  • Oil that has been stored for 12 months can not be used.
noteOil level should be level with bottom of filler plug mounting hole.
3. Set a gasket on filler plug, and install it to coupling oil tank cover.
cautionNever reuse gasket.
4. Tighten filler plug to the specified torque. Refer to Exploded View.
5. Perform air bleeding and initialize oil deterioration level of electro-hydraulic coupling oil. Refer to Description.
6. Check oil level for electro-hydraulic coupling oil again.
noteThe oil level may be reduced after air bleeding.
(1) Check oil level from filler plug mounting hole as shown in the figure after removing filler plug and gasket from coupling oil tank cover .
cautionTurn the ignition switch OFF while checking oil level.
  • Oil level should be level with bottom of filler plug mounting hole. Add electro-hydraulic coupling oil if necessary.
(2) Set a gasket on filler plug and install it on coupling oil tank cover.
cautionNever reuse gasket.
(3) Tighten filler plug to the specified torque. Refer to Exploded View.