[Previous][Next]
Work Procedure
noteBefore starting, make sure:
  • ASIST on the M.U.T.-III SE has been synchronized to the current date.
  • All M.U.T.-III SE software updates (if any) have been installed.
1.REPLACING
  1. The ignition switch is OFF.
  2. Replace AWD control unit (integrated with actuator assembly) or electro-hydraulic coupling assembly. Refer to Disassembly and Assembly.
: .
 
2.PERFORM AWD CONTROL UNIT PROGRAMMING
With M.U.T.-III SE
Perform AWD control unit programming according to the procedure of “Programming” in M.U.T.-III SE Operation Manual. Refer to M.U.T.-III SE Operation Manual.
cautionDuring programming, maintain the following conditions:
  • Ignition switch: ON
  • Engine: Stopped
  • Electric load: OFF
  • Brake pedal: Not depressed
  • Battery voltage: More than 11 V (Be sure to check the value of battery voltage by selecting “Battery voltage” in “Data List” of M.U.T.-III SE.)
: .
 
3.PERFORM AIR BLEEDING AND INITIALIZE OIL DETERIORATION LEVEL
Perform air bleeding and initialize oil deterioration level of electro-hydraulic coupling oil. Refer to Description.
: WORK END