[Previous][Next]
Work Procedure
noteBefore starting, make sure:
  • ASIST on the M.U.T.-III SE has been synchronized to the current date.
  • All M.U.T.-III SE software updates (if any) have been installed.
1.PRINT CURRENT CALIBRATION DATA
With M.U.T.-III SE
  1. The ignition switch is ON.
  2. Connect M.U.T.-III SE.
  3. Select “CALIB DATA” in “TRANSMISSION”.
  4. Print page 1 of 7.
    noteThis screen print is used for warranty documentation.
: .
 
2.CHECK THE SERIAL NUMBER (PART 1)
Write down the serial number of new transaxle assembly.
: .
 
3.CHECK THE SERIAL NUMBER (PART 2)
With M.U.T.-III SE
  1. The ignition switch is ON.
  2. Insert the supplied CD into M.U.T.-III SE.
  3. Select “Special Function” in “TRANSMISSION”.
  4. Select “WRITE IP CHARA - REPLACEMENT AT/CVT” of “IP characteristics data writing”.
  5. Touch “File import” to save the calibration file stored in the CD into M.U.T.-III SE.
  6. Touch “OK” on the “Select IP characteristics data file” window.
  7. Confirm that the serial number (calibration file number) displayed on M.U.T.-III SE screen matches the serial number (calibration file number) on the transaxle assembly.
  8. Touch “OK”.
: .
 
4.WRITE CALIBRATION DATA (IP CHARACTERISTICS VALUE)
noteWrite data of new solenoid in TCM according to the following instructions:
With M.U.T.-III SE
  1. The ignition switch is ON, engine OFF.
  2. Press the brake pedal.
  3. Depress the throttle pedal half way and hold, then press “OK” on the M.U.T.-III SE screen.
  4. Write data to the TCM according to the instructions on the M.U.T.-III SE screen.
    noteWhen the calibration data has been written to the TCM, the current status will indicate “Complete”.
: .
 
5.PRINT NEW CALIBRATION DATA
With M.U.T.-III SE
  1. Select “CALIB DATA” in “TRANSMISSION”.
  2. Print page 1 of 7.
    noteThis screen print is used for warranty documentation.
: .
 
6.PERFORM SELECT LEARNING (DRIVE/REVERSE LEARNING)
Perform Select Learning. Refer to Work ProcedureWork Procedure.
: .
 
7.PERFORM SHIFT ACTUATOR LEARNING
Perform shift actuator learning. Refer to Description.
: .
 
8.ERASE CVT FLUID DEGRADATION LEVEL DATA
With M.U.T.-III SE
  1. Select “WORK SUPPORT” in “TRANSMISSION”.
  2. Select “CONFORM CVTF DETERIORTN”.
  3. Touch “OK” .
  4. Clear any DTCs that may have set and then test drive the vehicle.
: WORK END