[Previous][Next]
Work Procedure
note
  • If Clutch Point Learning is also required, always perform Clutch Point Learning before Select Learning.
  • Perform Select Learning with CVT fluid temperature below 50°C (122°F) and again with fluid temperature above 50°C (122°F).
1.PERFORM SELECT LEARNING (DRIVE/REVERSE LEARNING)
  1. Set the parking brake.
  2. Start the engine and wait 5 seconds.
  3. Depress the brake pedal
  4. Shift the selector lever to the N position and hold more than 2 seconds, then to D position and wait for transmission engagement.
  5. Repeat step 3 ten (10) times.
  6. Shift the selector lever to the N position and hold more than 2 seconds, then to R position and wait for transmission engagement.
  7. Repeat step 5 ten (10) times.
  8. Shift the selector lever to the P position and turn the ignition OFF.
: WORK END