[Previous][Next]
DTC Diagnosis Procedure
1.CHECK CIRCUIT BETWEEN TCM AND CVT UNIT
  1. The ignition switch is OFF.
  2. Disconnect TCM connector and CVT unit connector.
  3. Check continuity between TCM harness connector terminal and ground.
    TCMContinuity
    ConnectorTerminal
    F7538GroundNot existed
Is the inspection result normal?
.
Repair or replace malfunctioning parts.
 
2.CHECK CIRCUIT BETWEEN CVT UNIT AND GROUND
Check resistance between CVT unit harness connector terminal and ground.
CVT unitConditionResistance
ConnectorTerminal
F2095GroundCVT fluid temperature: 20°C (68°F)5.5 – 7.0 Ω
CVT fluid temperature: 50°C (122°F)6.0 – 8.0 Ω
CVT fluid temperature: 80°C (176°F)6.5 – 8.5 Ω
Is the inspection result normal?
INSPECTION END
.
 
3.CHECK CIRCUIT BETWEEN CVT UNIT AND CONTROL VALVE
  1. Disconnect control valve connector. Refer to Removal and Installation.
  2. Check continuity between CVT unit harness connector terminal and ground.
CVT unitContinuity
ConnectorTerminal
F2095GroundNot existed
Is the inspection result normal?
.
Replace terminal cord assembly. Refer to Removal and Installation.
 
4.CHECK CIRCUIT BETWEEN CONTROL VALVE AND GROUND
Check resistance between control valve harness connector terminal and ground.
Control valveConditionResistance
Terminal
3GroundCVT fluid temperature: 20°C (68°F)5.5 – 7.0 Ω
CVT fluid temperature: 50°C (122°F)6.0 – 8.0 Ω
CVT fluid temperature: 80°C (176°F)6.5 – 8.5 Ω
Is the inspection result normal?
INSPECTION END
There is malfunction of torque converter clutch solenoid valve. Replace control valve assembly. Refer to Removal and Installation.