[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P085100PARK/NEUTRAL SWITCH
(Park/Neutral Switch Input Circuit Low)
Diagnosis conditionIgnition switch: ON
SignalP position switch signal
ThresholdThe input voltage is less than 0.6 V in one of P position switches No.1 and No.2.
Diagnosis delay time2.4 seconds
 
 
POSSIBLE CAUSE
  • Electric shift selector (P position switch)
  • Electric shift control module
  • Harness or connectors (P position switch circuit is shorted to ground.)
 
 
FAIL-SAFE
Pushing the P position switch does not switch to the P position
 
 
DTC CONFIRMATION PROCEDURE
1.PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always ignition switch OFF and wait at least 60 seconds before conducting the next test.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. The ignition switch is ON and wait for at least 5 seconds.
  2. Press the P position switch and hold for at least 5 seconds.
  3. Check DTC.
Is DTC detected?
Go to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END