[Previous][Next]
Diagnosis Procedure
1.CHECK ELECTRIC SHIFT SELECTOR INPUT VOLTAGE
Check the voltage between electric shift selector harness connector terminal and ground.
+ConditionVoltage
(Approx.)
Electric shift selector
ConnectorTerminal
M21GroundIgnition switch is ON5 V
13
Is the inspection results normal?
.
.
 
2.CHECK HARNESS BETWEEN ELECTRIC SHIFT CONTROL MODULE AND ELECTRIC SHIFT SELECTOR - 1
  1. The ignition switch is OFF.
  2. Disconnect the electric shift selector connector.
  3. Disconnect the electric shift control module connector.
  4. Check the continuity between the electric shift control module harness connector terminal and the electric shift selector harness connector terminal.
    Electric shift control moduleElectric shift selectorContinuity
    ConnectorTerminalConnectorTerminal
    E13019M21Existed
    E1314813
  5. Check the continuity between the electric shift control module harness connector terminal and ground.
    Electric shift control moduleContinuity
    ConnectorTerminal
    E13019GroundNot existed
    E13148
Is the inspection results normal?
Check intermittent incident. Refer to Intermittent IncidentIntermittent Incident.
Repair or replace damaged parts.
 
3.CHECK HARNESS BETWEEN ELECTRIC SHIFT CONTROL MODULE AND ELECTRIC SHIFT SELECTOR - 2
  1. The ignition switch is OFF.
  2. Disconnect the electric shift selector connector.
  3. Disconnect the electric shift control module connector.
  4. Check the continuity between the electric shift control module harness connector terminal and the electric shift selector harness connector terminal.
    P position switchElectric shift control moduleElectric shift selectorContinuity
    ConnectorTerminalConnectorTerminal
    Switch 1E13146M26Existed
    Switch 24718
  5. Check the continuity between the electric shift control module harness connector terminal and ground.
    P position switchElectric shift control moduleContinuity
    ConnectorTerminal
    Switch 1E13146GroundNot existed
    Switch 247
  6. Check the continuity between the electric shift control module harness connector terminals.
    P position switchElectric shift control moduleElectric shift control moduleContinuity
    ConnectorTerminalConnectorTerminal
    Switch 1E13146E131Except 46Not existed
    Switch 247Except 47
Is the inspection results normal?
.
Repair or replace damaged parts.
 
4.REPLACE ELECTRIC SHIFT SELECTOR
  1. Replace the electric shift selector. Refer to Removal and Installation.
  2. Connect all of disconnected connectors.
  3. Perform DTC confirmation procedure. Refer to DTC Description.
Is DTC detected?
Replace the electric shift control module. Refer to Removal and Installation.
INSPECTION END