[Previous][Next]
Description
cautionWhen replacing the TCM, always replace it with a new one. The functions controlled by the TCM does not operate properly in case of reuse of the TCM from another vehicle.
Always perform the following work when TCM is replaced. For work procedure, refer to Work Procedure.
 
 
WORK BEFORE TCM REPLACEMENT
  • Calibration data (IP characteristics value) saving
    noteTCM performs accurate control by retrieving data (inherent characteristic value) of each solenoid. For this reason, it is necessary to save data of current TCM in M.U.T.-III SE before replacing the TCM. After this, the saved data must be written in new TCM.
 
 
WORK AFTER TCM REPLACEMENT
  • TCM programming
    noteSince vehicle specifications are not yet written in a new TCM, it is necessary to write them with M.U.T.-III SE.
  • MAC key writing
  • Calibration data (IP characteristics value) writing
    noteTCM performs accurate control by retrieving data (inherent characteristic value) of each solenoid. The data stored in M.U.T.-III SE must be written in new TCM.
  • Clutch point learning
  • Select learning (Drive/Reverse learning)
  • G sensor calibration