[Previous][Next]
Component Inspection (Crankshaft Position sensor)
1.CHECK CRANKSHAFT POSITION SENSOR-1
  1. Turn ignition switch OFF.
  2. Loosen the fixing bolt of the sensor.
  3. Disconnect crankshaft position sensor harness connector.
  4. Remove the sensor.
  5. Visually check the sensor for chipping.
Is the inspection result normal?
.
Replace crankshaft position sensor. Refer to Exploded View.
 
2.CHECK CRANKSHAFT POSITION SENSOR-2
Check the resistance between crankshaft position sensor terminals as per the following.
Crankshaft position sensorResistance [at 25°C (77°F)]
+
Terminal (Polarity)
12
Except 0 or ∞Ω
3
23
Is the inspection result normal?
INSPECTION END
Replace crankshaft position sensor. Refer to Exploded View.