1.CHECK DTC PRIORITY
If DTC P2014 is displayed with DTC P06B0, first perform the trouble diagnosis for DTC P06B0.Is applicable DTC detected?
.
2.CHECK INTAKE MANIFOLD RUNNER CONTROL VALVE POSITION SENSOR POWER SUPPLY
3.CHECK INTAKE MANIFOLD RUNNER CONTROL VALVE POSITION SENSOR POWER SUPPLY CIRCUIT
Check the voltage between intake valve manifold runner control valve position sensor harness connector and ground.+ | - | Voltage (Approx.) |
Intake manifold runner control valve position sensor |
Connector | Terminal |
F20 | 1 | Ground | 5 V |
Is the inspection result normal?
. Perform the trouble diagnosis for power supply circuit.
4.CHECK ECM GROUND CIRCUIT
- Turn ignition switch OFF.
- Disconnect ECM harness connector.
- Check the continuity between ECM harness connector and ground.
+ | - | Continuity |
ECM |
Connector | Terminal |
F51 | 4 | Ground | Existed |
E16 | 156 |
157 |
160 |
- Also check harness for short to power.
Is the inspection result normal?
Repair or replace error-detected parts.
5.CHECK INTAKE MANIFOLD RUNNER CONTROL VALVE POSITION SENSOR GROUND CIRCUIT
6.CHECK INTAKE MANIFOLD RUNNER CONTROL VALVE POSITION SENSOR INPUT SIGNAL CIRCUIT
7.CHECK INTERMITTENT INCIDENT
Refer to Intermittent IncidentIntermittent Incident.Is the inspection result normal?
Repair or replace error-detected parts.