[Previous][Next]
DTC Diagnosis Procedure
1.CHECK KNOCK SENSOR 1 GROUND CIRCUIT
  1. Turn ignition switch OFF.
  2. Disconnect knock sensor 1 harness connector.
  3. Disconnect ECM harness connector.
  4. Check the continuity between knock sensor 1 harness connector and ECM harness connector.
    +Continuity
    Knock sensor 1ECM
    ConnectorTerminalConnectorTerminal
    F42F5153Existed
  5. Also check harness for short to power.
Is the inspection result normal?
.
Repair or replace error-detected parts.
 
2.CHECK KNOCK SENSOR 1 INPUT SIGNAL CIRCUIT
  1. Check the continuity between knock sensor 1 harness connector and ECM harness connector.
    +Continuity
    Knock sensor 1ECM
    ConnectorTerminalConnectorTerminal
    F41F5149Existed
  2. Also check harness for short to ground and to power.
Is the inspection result normal?
.
Repair open circuit or short to ground or short to power in harness or connectors.
 
3.CHECK KNOCK SENSOR 1
Check the knock sensor 1. Refer to Component Inspection.
Is the inspection result normal?
Check intermittent incident. Refer to Intermittent IncidentIntermittent Incident.
Replace knock sensor 1. Refer to Exploded View.