[Previous][Next]
DTC Description
The heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage capacity of the three way catalyst (manifold) causes the longer switching time.
MALFUNCTION A
To judge the malfunctions of heated oxygen sensor 2, ECM monitors whether the voltage is unusually high during various driving conditions such as fuel cut.
MALFUNCTION B
To judge the malfunctions of heated oxygen sensor 2, ECM monitors whether the minimum voltage is excessively high during various driving conditions such as fuel cut.
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P227000O2 sensor signal bank 1 sensor 2
(O2 Sensor Signal Biased/Stuck Lean Bank 1 Sensor 2)
ADiagnosis condition
Signal (terminal)Heated oxygen sensor 2 signal
ThresholdAn excessively high voltage from the sensor is sent to ECM
Diagnosis delay time
BDiagnosis condition
Signal (terminal)Heated oxygen sensor 2 signal
ThresholdThe minimum voltage from the sensor is not reached to the specified voltage
Diagnosis delay time
 
 
POSSIBLE CAUSE
 
 
P2270-A
  • Harness or connectors (The heated oxygen sensor 2 circuit is open or shorted.)
  • Heated oxygen sensor 2
 
 
P2270-B
  • Harness or connectors (The heated oxygen sensor 2 circuit is open or shorted.)
  • Heated oxygen sensor 2
  • Fuel pressure
  • Direct fuel injector
  • Port fuel injector
 
 
FAIL-SAFE
Not applicable
 
 
DTC Confirmation Procedure
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
: .
 
2.DTC CONFIRMATION PROCEDURE FOR MALFUNCTION A
  1. Start engine and warm it up to the normal operating temperature.
  2. Turn ignition switch OFF and wait at least 10 seconds.
  3. Restart engine and keep the engine speed between 3,500 and 4,000 rpm for at least 1 minute under no load.
  4. Check 1st trip DTC.
Is 1st trip DTC detected?
Refer to DTC Diagnosis Procedure.
-2Without M.U.T.-III SE: .
 
3.PERFORM COMPONENT FUNCTION CHECK
Perform Component Function Check. Refer to Component Function Check.
Is the inspection result normal?
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: .
Refer to DTC Diagnosis Procedure.
 
4.ERASE DTC
Erase DTC of ECM.
: INSPECTION END