[Previous][Next]
Component Function Check
1.PERFORM COMPONENT FUNCTION CHECK-1
Without M.U.T.-III SE
  1. Start engine and warm it up to normal operating temperature.
  2. Turn ignition switch OFF and wait at least 10 seconds.
  3. Start engine and keep the engine speed between 3,500 and 4,000 rpm for at least 1 minute under no load.
  4. Let engine idle for 1 minute.
  5. Check the voltage between ECM harness connector and ground as per the following condition.
    ECMConditionVoltage
    Connector+
    Terminal
    F529297Revving up to 4,000 rpm under no load at least 10 timesThe voltage should be above 0.71 V at least once during this procedure.
Is the inspection result normal?
INSPECTION END
.
 
2.PERFORM COMPONENT FUNCTION CHECK-2
Check the voltage between ECM harness connector and ground as per the following condition.
ECMConditionVoltage
Connector+
Terminal
F529297Keeping engine speed at idle for 10 minutesThe voltage should be above 0.71 V at least once during this procedure.
Is the inspection result normal?
INSPECTION END
.
 
3.PERFORM COMPONENT FUNCTION CHECK-3
Check the voltage between ECM harness connector and ground as per the following condition.
ECMConditionVoltage
Connector+
Terminal
F529297Coasting from 80 km/h (50 MPH) in D positionThe voltage should be above 0.71 V at least once during this procedure.
Is the inspection result normal?
INSPECTION END