[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
P062F00CONTROL MODULE
(Internal control module EEPROM error)
Diagnosis conditionIgnition switch ON
Signal (terminal)
ThresholdEEPROM (built-in microcomputer) system internal ECM does not function properly
Diagnosis delay time
 
 
POSSIBLE CAUSE
ECM
 
 
FAIL-SAFE
Not applicable
 
 
DTC Confirmation Procedure
1.PRECONDITIONING
If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is between 11 V  or more with ignition switch ON.
: .
 
2.PERFORM DTC CONFIRMATION PROCEDURE
  1. Turn ignition switch ON and wait at least 1 second.
  2. Turn ignition switch OFF and wait at least 10 seconds.
  3. Repeat step 1 and 2 for 10 times.
  4. Erase DTC.
  5. Turn ignition switch OFF and wait at least 10 seconds
  6. Turn ignition switch ON.
  7. Check the DTC.
Is the DTC detected?
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END