[Previous][Next]
Component Inspection
1.CHECK EVAP CANISTER PURGE VOLUME CONTROL SOLENOID VALVE
With M.U.T.-III SE
  1. Turn ignition switch OFF.
  2. Reconnect all harness connectors disconnected.
  3. Disconnect EVAP purge hoses connected to EVAP canister purge volume control solenoid valve.
  4. Start engine.
  5. Select "PURG VOL CONT/V" in "Actuator Test" (in "Special Function") mode of "ENGINE" using M.U.T.-III SE.
  6. Adjust “PURG VOL C/V” opening and check air passage continuity of EVAP canister purge volume control solenoid valve as per the following conditions.
Condition
(PURG VOL C/V value)
Air passage continuity
between (A) and (B)
100%Existed
0%Not existed
 
Without M.U.T.-III SE
  1. Turn ignition switch OFF.
  2. Disconnect EVAP canister purge volume control solenoid valve harness connector.
  3. Disconnect EVAP purge hoses connected to EVAP canister purge volume control solenoid valve.
  4. Check air passage continuity of EVAP canister purge volume control solenoid valve as per the following conditions.
    ConditionAir passage continuity
    between (A) and (B)
    12 V direct current supply between terminals 1 and 2Existed
    No supplyNot existed
 
Is the inspection result normal?
INSPECTION END
Replace EVAP canister purge volume control solenoid valve. Refer to Removal and Installation.