[Previous][Next]
Component Inspection
1.CHECK ACCELERATOR PEDAL POSITION SENSOR
  1. Turn ignition switch OFF.
  2. Reconnect all harness connectors disconnected.
  3. Turn ignition switch ON.
  4. Check the voltage between ECM harness connector terminals as per the following condition.
    ECMConditionVoltage
    Connector+
    Terminal
    Sensor 1E16158159Accelerator pedalFully released0.76 V
    Fully depressed4.57 V
    Sensor 2151152Fully released0.39 V
    Fully depressed2.3 V
Is the inspection result normal?
INSPECTION END
Replace accelerator pedal assembly. Refer to Removal and Installation.