[Previous][Next]
Removal and Installation
 
 
REMOVAL
caution
  • Never disassemble accelerator pedal assembly. Never remove accelerator pedal position sensor from accelerator pedal assembly.
  • Avoid impact from dropping etc. during handling.
  • Be careful to keep accelerator pedal assembly away from water.
 
 
1. Loosen mounting bolts, and remove accelerator pedal assembly.
2. Disconnect accelerator pedal position sensor harness connector.
 
 
INSTALLATION
Note the following, and install in the reverse order of removal.
  • Install the protrusion of the bracket into the locating hole of the accelerator pedal assembly before tightening the accelerator pedal assembly mounting bolts.
    : Locating pin
    caution
    • When inserting accelerator pedal assembly to protrusion , never scratch locating hole with the protrusion.
    • Tighten bolts with the locating pin securely inserted in the bracket hole.
cautionWhen harness connector of accelerator pedal position sensor is disconnected, perform “ACCELERATOR PEDAL RELEASED POSITION LEARNING”. Refer to DescriptionDescription.