[Previous][Next]
Removal and Installation
 
 
REMOVAL
 
 
1. Remove the engine and transaxle. Refer to Removal and Installation.
2. Separate engine from transaxle.
3. Remove drive plate. Refer to Removal and Installation.
4. Remove rear oil seal with a suitable tool.
caution
  • Be careful not to damage crankshaft and cylinder block.
  • Do not reuse rear oil seal.
 
 
INSTALLATION
 
 
1. Apply new engine oil to seal lip.
2. Install rear oil seal so that each seal lip is oriented as shown in the figure.
: Dust seal lip
: Oil seal lip
: Drive plate side
: Engine front
  • Press-fit rear oil seal with a suitable drift (A).
    caution
    • Be careful not to damage crankshaft and cylinder block.
    • Press-fit oil seal straight to avoid causing burrs or tilting.
    • Do not reuse rear oil seal.
  • Press in the new rear oil seal to the position shown in the figure.
    : Rear surface of cylinder block
    : 0 - 0.5 mm (0 - 0.020 in)
3. Install in the reverse order of removal after this step.