1. Install pilot converter.
2. Install drive plate in the reverse order of removal.- Install drive plate , reinforcement plate and pilot converter as shown in figure.
| : Crankshaft rear end |
| : Rounded |
| : Chamfered |
| : Engine front |
- Using a drift of 33 mm (1.30 in) in diameter, press-fit pilot converter into the end of crankshaft until it stops.
caution | Be careful not to damage or scratch the signal plate. |
3. Temporarily tighten drive plate bolts in a diagonal order over several steps.
4. Tighten drive plate bolts using a suitable tool in a diagonal order over several steps.
5. Installation of the remaining components is in the reverse order of removal.