Removal and Installation
REMOVAL
1.
Remove the following parts.
Engine under cover front. Refer to
Removal and Installation
.
Front fender protector: Refer to
Removal and Installation
.
Drive belt: Refer to
Removal and Installation
.
Crankshaft pulley: Refer to
Removal and Installation
.
2.
Remove front oil seal with a suitable tool.
caution
Be careful not to damage front cover and crankshaft.
Do not reuse front oil seal.
INSTALLATION
1.
Apply new engine oil to seal lip.
2.
Install front oil seal so that each seal lip is oriented as shown in the figure.
: Dust seal lip
: Oil seal lip
: Engine outside
: Engine inside
Press-fit front oil seal until it is flush with front end surface of front cover using a suitable drift (A).
caution
Be careful not to damage front cover and crankshaft.
Press-fit oil seal straight to avoid causing burrs or tilting.
Never touch the grease applied to the oil seal lip.
Do not reuse oil seal.
3.
Install in the reverse order of removal after this step.