Removal and Installation
REMOVAL
1.
Remove rear bumper fascia. Refer to
Removal and Installation
.
2.
Release the lock
as shown by the arrow in the figure and disconnect the harness connector from the side radar.
3.
Press the pawls
and remove the side radar
.
INSTALLATION
Installation is in the reverse order of removal.
caution
Do not use side radar if lens has flaws.
If side radar is being replaced or has been disconnected, perform "ADDITIONAL SERVICE WHEN REPLACING SIDE RADAR". Refer to
Work Procedure
.
note
Do not touch side radar lens and keep lens area clean.
![[Previous]](../../../buttons/fprev.png)
![[Next]](../../../buttons/fnext.png)
.
as shown by the arrow in the figure and disconnect the harness connector from the side radar.)
and remove the side radar.)