[Previous][Next]
Removal and Installation
 
 
REMOVAL
 
 
1. Remove the headlining assembly. Refer to Removal and Installation.
2. Remove the mounting bolt, and then remove the washer and antenna holder .
3. Disconnect the roof antenna connector, and then remove the roof antenna.
 
 
INSTALLATION
  1. Insert the antenna assembly into the roof.
  2. Tighten the pre-assembled (bolts, washers, holder) mounting bolts .
noteIf only bolt, washer or antenna holder needs to be replaced, it can be ordered separately.
caution
  • Be careful about tightening torque. Antenna sensitivity becomes poor, and when it is excessive, roof panel may be deformed, when roof antenna mounting bolt tightening torque is loose.
  • Be sure to replace the washer during installation (not reusable).
  • Be sure to replace antenna holder as well, if the antenna holder is cracked or damaged.