[Previous][Next]
DTC Description
 
 
DTC DETECTION LOGIC
DTCM.U.T.-III SE screen terms
(Trouble diagnosis content)
DTC detection condition
B2A1B-31Right camera
(Right camera)
Diagnosis conditionWhen ignition switch is ON
Signal (terminal)LVDS (side camera RH)
ThresholdCommunication error with side camera RH
Diagnosis delay time30 seconds or more
 
 
POSSIBLE CAUSE
  • LVDS cable (between around view monitor control unit and side camera RH)
  • Side camera RH
 
 
FAIL-SAFE
  • Camera image not displayed
  • MOD (Moving Object Detection) function is stopped.
 
 
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With M.U.T.-III SE
  1. Turn the ignition switch ON.
  2. Turn ignition switch OFF and wait at least 30 seconds.
  3. Turn ignition switch ON and wait at least 30 seconds or more.
  4. Select “Self Diagnostic Result” mode of “Multi Around Monitor” using M.U.T.-III SE.
  5. Check DTC.
Is DTC B2A1B-31 detected?
Refer to Diagnosis Procedure.
-1To check malfunction symptom before repair: Refer to Intermittent IncidentIntermittent Incident.
-2Confirmation after repair: INSPECTION END